Gauteng ยท Vetted local plumbers

Geyser leaking from the overflow pipe: normal or a fault?

A few drips while the geyser heats up are normal. A steady flow, or water running when nobody is using hot water, means a fault that needs a plumber.

Covers
Johannesburg, Pretoria, Ekurhuleni, the West Rand and the Vaal
You pay
Nothing to be put in touch
Price
Quoted before work starts

Why the pipe exists

A geyser has a safety valve that lets water out when the temperature or pressure gets too high. That water leaves through a pipe that must run outside the building. This is the pipe you see dripping.

Under SANS 10254, which covers fixed electric storage water heaters, the drip tray under the geyser also needs its own overflow pipe that drains outside, not into the ceiling.

When dripping is normal

Water expands as it heats. When the geyser is heating, especially on a hot day or after a lot of hot water was used, a little water can be pushed out of the valve. It should stop once heating finishes.

Watch it for a day. If it drips for a short while after the element switches on and then stops, that is the system working.

A useful test is the timing. Note whether the dripping starts a short while after the element switches on, and whether it stops when the water is hot. If it also drips in the middle of the night with no hot water used, the cause is more likely high supply pressure or a failing valve than ordinary expansion.

When it points to a fault

Plumbers and geyser makers link steady dripping to these causes:

  • A pressure control valve that has failed or is worn.
  • Municipal pressure that is higher than the geyser is meant to take.
  • A thermostat fault causing the water to overheat, which can show up as a constant stream or steam.
  • A worn safety valve that no longer seals.
  • Rusty brown water coming out, which can point to corrosion inside an older tank.

What never to do

Never block, cap or plug the overflow pipe. It is a required safety device, and a blocked pipe can let pressure build until the geyser bursts.

Keep your hands and face away from the pipe. The water can be scalding hot.

If a heavy flow or steam is coming out, switch off the geyser at the isolator on the DB board and close the geyser's isolating valve or the water mains. Do not touch the electrical side of the geyser itself.

If you are not sure the pipe you are looking at is the safety valve outlet, look at where the pipe starts. The safety valve is on the geyser itself. A pipe from the drip tray, if you have one, carries only leaked water. Either way, a steady discharge means something is wrong.

Getting it looked at

A geyser that drips constantly is worth checking before it turns into a burst geyser and a flooded ceiling. A local plumber can test the valves and pressure, and tell you whether it is a cheap valve or an ageing tank. They quote before they start.

Send us your suburb and a short description on WhatsApp and we will find someone close by.

The job behind this: Burst geyser and insurance claims.

Questions people ask

How much dripping is too much?

A few drops while heating is fine. If water runs steadily, runs when no hot water is used, or makes a puddle outside, treat it as a fault.

Can I fix the valve myself?

Valves on a geyser are safety devices and a poor repair can cause a burst. Switch off power at the DB and call a registered plumber.

Does dripping mean my geyser is about to burst?

Not always, but steady dripping can be an early warning if the pressure valve has failed. Do not ignore it.

Related problems

All common problems →

Tell us what is wrong

Takes under a minute. A plumber near your area phones you back and quotes before any work starts. There is nothing to pay to be put in touch.