Step 1: how widespread is it?
Run a few taps. Check the kitchen, the bathroom and an outside tap. The pattern tells you most of what you need.
- One tap only: the problem is in that tap.
- Hot water only: the problem is on the geyser side.
- Cold water everywhere: the supply, a valve or a regulator.
- Only upstairs or at the highest tap: this is often normal supply pressure and a plumber can discuss a pump.
One tap: the aerator
The aerator is the small screen on the spout. Grit and limescale block it. Unscrew it, rinse it and soak it in vinegar for an hour if there is scale. Put it back and test. If the flow is still weak, the tap's cartridge or the flexible hose under the basin may be blocked.
The same steps apply to a shower head. Soak it in vinegar for an hour and use a toothpick to clear the holes. In areas with hard water, scale is a common cause of a weak shower.
The whole house: start at the valve
A main valve that is only partly open is a common cause, and the fix takes ten seconds. Check the valve at the meter or where the pipe enters the house.
Ask a neighbour whether their pressure is low too. If it is, the municipal supply may be the cause, and the municipality is the one to contact.
If the low pressure started right after plumbing work or after the water was cut off, air in the pipes or a valve left half closed is likely. Open the taps one at a time and let them run until the flow settles. Check any isolating valve that was touched during the work.
The pressure regulator
Many homes have a pressure control or reducing valve on the incoming line. If it fails or is set too low, the whole house feels weak. Adjusting or replacing one is a plumber's job, because a wrong setting can damage the geyser or appliances.
Old galvanised pipes can also clog with rust and reduce flow over the years, which would call for a plumber's assessment.
Pressure can also be too high. Very strong pressure damages taps, hoses and the geyser's valves, and may be the reason a geyser overflow keeps dripping. A regulator solves that too, and it is a plumber's job to fit and set.
When to call a plumber
Call if the whole house is weak and the valve is open, if the pressure dropped suddenly with a higher water bill, or if you hear running water when everything is off. That can be a leak, and the meter test will confirm it.
A local plumber can test the pressure and tell you what needs replacing. Send us your suburb and the pattern you found, and they quote before starting.
The job behind this: Taps, mixers and water pressure.