Gauteng ยท Vetted local plumbers

Is my pool leaking or evaporating? Do the bucket test

Every pool loses some water to sun and wind. The bucket test shows whether yours loses more than that, and it needs only a bucket, a marker and a day.

Covers
Johannesburg, Pretoria, Ekurhuleni, the West Rand and the Vaal
You pay
Nothing to be put in touch
Price
Quoted before work starts

How the bucket test works

A bucket of water sitting in the pool loses water to evaporation at the same rate as the pool does. If the pool drops further than the bucket, the extra loss is going somewhere it should not.

Step by step

Do this on a normal, calm day. Switch off any automatic top-up or float valve first, or the test tells you nothing.

  • Fill a bucket with pool water to about 5 cm from the top.
  • Put it on a pool step so the water inside is level with the water outside. Weigh it down with a stone if it floats.
  • Mark the water level inside the bucket with tape or a marker.
  • Mark the pool level on the outside of the bucket, or on the skimmer or tile.
  • Do not backwash, top up or let people swim for 24 hours. Splash-out ruins the result.

Reading the result

After a day, compare the two marks. If the pool and the bucket dropped by about the same amount, the loss is evaporation and the pool is fine.

If the pool dropped clearly more than the bucket, you have a leak. A difference of a centimetre or so over 24 hours is the rule of thumb most guides use. If the result is close, repeat it on another dry day before you decide anything.

Weather changes the answer. A hot, windy day can pull a surprising amount of water out of a pool, and an uncovered pool in a Gauteng summer loses more than a covered one in winter. That is why the bucket sits in the pool: it faces the same sun and wind, so the weather cancels out and only the leak is left.

Write the result down with the date. If you test again in a month, you can see whether the loss is getting worse.

Pump on, pump off

A second round narrows down where the leak is. Run the test once with the pump running all day and once with it switched off.

If the pool only loses extra water while the pump runs, the leak is likely in the pipework or equipment, which is under pressure when the pump runs. If it loses water either way, the shell, a light fitting or a skimmer is more likely. This is only a pointer. The bucket test cannot tell you the exact spot.

Other signs of a pool leak

The bucket test is not the only clue. Look around the pool for these:

  • Wet, soggy or sunken ground near the pool or the pump area.
  • Cracked tiles or coping.
  • Chemicals that are hard to keep balanced because you keep topping up with fresh water.
  • Water around the pump, filter or valves.
  • A higher water bill that you cannot explain.

What to do next

If the bucket test says leak, stop topping up blindly. Note how many centimetres the pool loses a day and keep that figure.

A local plumber with pool leak detection gear can find the leak without digging up the whole garden, and they quote before they start. Send us the pool type and your suburb on WhatsApp and we will put you onto someone nearby.

The job behind this: Pool leak detection.

Questions people ask

How much water loss is normal for a pool?

It depends on heat, wind and whether you use a cover, so there is no single number. The bucket test removes the guesswork because it compares your pool against the same weather.

Can I run the bucket test if it rained?

Rain adds water to both the bucket and the pool but spoils the comparison. Wait for a dry spell and repeat the test.

Should I keep topping up the pool?

Top up enough to keep the pump from running dry, but record how much you add. A leak can wash out chemicals and may damage the pump if the level drops below the skimmer.

Related problems

All common problems →

Tell us what is wrong

Takes under a minute. A plumber near your area phones you back and quotes before any work starts. There is nothing to pay to be put in touch.